Carbon Paper is a thin paper which has an ink layer on one side.
Then just peel off the paper backing – the backside is sticky – and press it onto your fabric. Make quick experimental drawings using carbon copy paper.
It's basically an 8.5x11 sheet of stabilizer that you can put right into your printer. It makes stitching easier by stabilizing your fabric, so it's good for stretch-knit fabrics (like tees), or felt. Whatever your preferences, choose a paper that is available in larger sizes. It takes a lot of graphite and is heavy enough to be used many times. It works wonderfully for designs with a lot of detail and a lot of lines (like mine) or for stitching onto dark fabrics. Paper You can use almost any paper that’s smooth and sturdy. It is a little pricier (usually about $1 per sheet) but I've gotten such great results with this material, it is definitely worth the cost. This is by far the easiest and most precise method. Is Designing Your Artwork by Hand Time-Consuming and Tiring MyArtscape Graphite Transfer Paper is a specialized transfer paper that uses carbon to transfer. MAGIC METHOD (aka printable sticky-back water-soluble stabilizer) Lift the paper carefully, one corner at a time, to be sure that the image has transferred completely. Check the instructions on your transfer pencil for recommended times. I am not a novice and have used similar products, although. Using a hot dry iron, press firmly (don’t rub, as this may cause it to smudge) on each section of the image until the entire image has been transferred. Attempts have been made to use a more viscous carbon ink composition which is less likely to pass through the fine pores of the tissue paper. Perfect for transferring pattern markings onto the wrong side of fabric, this dressmakers carbon.Lay the tracing paper, drawing side down, on top of the fabric.Once the image is traced, you are ready to transfer it to fabric.Use small pieces of tape at the corners to keep the papers in place while you are tracing. Place a piece of tracing paper over the pattern pieces and trace the design onto your tracing paper using the iron-on pen.But if your design has text, or if you want to use the original image and not the mirror image, you can either print it as a mirror image OR flip the pattern over and trace it from the back. Keep in mind that you'll be placing the image face-down to iron it onto your fabric, so it will print backwards. With this method, you'll basically be tracing and ironing.
0 kommentar(er)
